Powered Temp-Vent systems are designed for foundations that require a higher rate of airflow and for areas that are difficult to vent. Depending on the model they can move large amounts of air per hour. Designed to run continuously on a low speed, they draw minimal electricity. However, Temp-Vent recommends power vents be fitted with a thermostat and a humidistat to control the operation of the vent. 
(Vented vs. Sealed Crawlspaces)

To Specify:
To determine the correct number of Power Temp-Vents, use the following formula:

1. Multiply the square feet of the crawl space by the height in feet. This gives the number of cubic feet in the crawl space.

2. Multiply the cubic feet in the crawl space by the number of air changes per hour desired (4-6 is the recommendation). This gives the total number of cubic feet of air that has to be moved per hour to produce the desired number of air changes.

3. Divide this number by either 7,200 or 11,160 — depending on which model is being used — to obtain the number of power vents needed.

4. Install Automatic vents to provide air intake on one side of the foundation with the power vents on the other side to create a system of intake and exhaust.

CUSTOMER FEEDBACK
Glad to take the time to recognize a level of service that stands out. Have been half-heartedly looked for foundation vent wells for years. The locals that woulda' and shoulda' had them didn't so I knew this task would be governed by one or several of "Murphy's Laws"!

I found them by chance at your site...ordered on-line and rec'd exactly what I expected within a couple of days. I was so impressed I installed both within two days!

Whatever system you have in place is working...more important, the employee(s) who monitor e-orders and start the ball rolling are earning their paycheck(s)...not to mention the rest of those involved in locating, packing and shipping! Again, thank you!

Fred M

Series 6   FREE SHIPPING Cost...$122.00 Model TVHPS6 Chose your color at checkout   FREE SHIPPING Cost...$134.00 Model TVQPS6 Chose your color at checkout       Series 5 We advise you to purchase the Series 6 unless you have a real good reason for needing the series 5 with the removable front frame. The series 6 is very easy to install and cost less. The series 5 is labor intensive. Instructions below. Installation Instructions for the Series 5   FREE SHIPPING Cost...$169.00 Model TVHPS5 Chose your color at checkout   FREE SHIPPING Cost...$179.00 Model TVQPS5 Chose your color at checkout   These units have a 5 yr warranty & can be powered with a drop cord. All of these vents are automatic like regular Automatic Vents. Opens at 70 degrees and closes at 40. The removable front grill on the series 5 has no bearing on the operation of the vents. It is just a preference of some installers. Actual dimensions of the Power Vent that fits in the vent hole is 7 3/4" wide x 15 3/4" long with a depth of 11 inches. There is also a 1" lip on the outside perimeter of the vent. These sizes apply to both the Series 5 & 6 Make sure you measure first, there is a 30% restocking fee to return these vents. Frequently Asked Questions	Totally enclosed motors feature a 3-prong plug and are 0.01 HP rated (quiet model) or 0.017 HP rated (high output model) for continuous operation. UL recognized and CSA certified. Series 6 is a one-piece vent and Series 5 vents have a removable front grill that can be snapped on after installation. A high output model with a larger motor and a quiet model with a smaller motor are both available. (See specifications.) Power vents should be placed on one side of the house with non-powered vents that act as intake vents, on the other side. A Thermostat should be used to turn the fan off in freezing weather to protect pipes under the home and save energy. A Humidistat should also be connected to the fan to control the operation of the vent. A damp weather shut-off humidistat will turn the unit off when it's raining outside. A Duct System is available that attaches to a powered foundation vent to provide targeted ventilation in hard to reach areas.
Save on bulk purchases of any of the power vents. You can mix your vents to get your best price. Orders of 12 to 36 power vents...............$121.00 eh  Orders of 37 to 72 power vents...............$117.00 eh  Orders of 73 to 120 power vents.............$112.00 eh  Orders of 121 power vents or more.........$105.00 eh Best to call these orders in at 1.877.800.6884
Radon Model   FREE SHIPPING Cost.........$127.00  Quiet FREE SHIPPING Cost.........$127.00   High Output Click here for a statement from the manufacturers concerning the Radon Vent	The Temp Vent Radon Model The Power Temp-Vent Radon Model uses positive pressure ventilation to help reduce potentially harmful radon from the crawl space. It also reduces radon emission from the soil in the crawl space.

Thermostat Pre-Wired Model TH FREE SHIPPING $99.00 each

Thermostats Set at approximately 50° F, the thermostat turns the unit off when the crawl space temperature drops below the setting. Normally, when the temperature outside is at 40 degrees the temperature in the crawl space is approximately 50 degrees. The thermostat helps protect pipes and save energy by turning the vent off when the temperature is close to freezing.

Save on bulk purchases of Thermostats Orders of 12 to 36 Thermostats...............$90.00 eh Orders of 37 to 83 Thermostats...............$86.00 eh Orders of 84 or more Thermostats...........$80.00 eh   Best to call these orders in at 1.877.800.6884
Model B Damp Weather Humidistat Model HUB FREE SHIPPING $103.00 each Model C Humidistat Model HUC FREE SHIPPING $95.00 each Click here for a statement from the manufacturers concerning the above controllers Thermostat & Humidistat Frequently Asked Questions	Humidistats A humidistat can connect to the Power Temp-Vent to turn the fan on and off automatically. Two types of humidistats are available. • Model B: Damp weather humidistat, mounts behind an intake vent, opposite the side where the power vent is mounted. Power vents stay off when the humidity is above the setting. The vent turns on when humidity is below the setting or if there is a quick rise in humidity, so that the unit turns off when it is raining. • Model C: Turns unit on when humidity in crawl space rises above a pre set limit, usually set at 50% humidity. The Humidistat / Thermostat system can be used to control up to 6 power vents
Save on bulk purchases of Humidistats Model B Orders of 12 to 36 Humidistats ...............$90.00 eh Orders of 37 to 83 Humidistats............... $86.00 eh Orders of 84 or more Humidistats..........  $80.00 eh   Best to call these orders in at 1.877.800.6884 Save on bulk purchases of Humidistats Model C Orders of 12 to 36 Humidistats ...............$86.00 eh Orders of 37 to 83 Humidistats............... $81.00 eh Orders of 84 or more Humidistats..........  $75.00 eh   Best to call these orders in at 1.877.800.6884

Duct System FREE SHIPPING Model DU This purchase includes only the Duct with Screen & Tape. Purchase Adapter separately below $79.95 each   Duct Adapter Model AD-1 FREE SHIPPING $77.00 each

Duct System The Power Temp-Vent Duct System is ideal for homes with difficult-to-ventilate situations including: • Porch areas • Obstructed, divided or unusually shaped crawl spaces • Interior walls in crawl spaces or weeping foundation walls • Heating, air conditioning or water heater obstructions • Special condensation areas A Power Temp-Vent combined with a Duct Adapter and Flexible Duct pulls dead, moist air from the area through the duct, then exhausts it outside through the power vent.

Vent Well The unit measures Approx : 24" wide by 12½" high and 10" deep. Vent Well Model VW FREE SHIPPING Cost..........$62.50          Chose your color at checkout